Hotel wooden door before installation measurement conditions and the actual measurement

the hotel before the wood door installation, surveyors to measure the doorway, just so you can make the right wooden door, but the measure next to it was time to consider some factors, or install door will appear a lot of trouble. Different series door all have different structure size, when the ground construction attention should be paid to different material separating position ( The floor and floor, floor brick and pressure) 。 , such as customer blank wall thickness, the width or height in the measurement data does not accord with standard sizes, when the customer before installation construction group in the finished product door entry will make their own construction, restructuring available plank brick, stone, such as increasing/pick carved wall battlements, higher/lower door, etc. Avoid finished product door cannot successful installation.

wooden door before measurement must comply with the conditions of a hotel:

1, customers, and the construction must be on the scene, head of the

2, horizontal lines, hutch defends need to prepare, wall, floor tile floor room needs leveling the ground. The height of the wall, floor tile, floor to determine.

3, reconstruction of water and electricity and the wall must be completed.

hotel wooden door actual measuring method

1, single side wall to confirm the gate size:

1) single wall openings is wall thickness corresponding to the flat wall, its about to the asymmetric structure, plane wall increase must be part of the wall, so that a solid frame and frame assembly line. Under the condition of used 60 mm wide door cover line to the wall width of 35 - 40mm; 80 mm wide door cover line cases for 55 - to the wall width 60mm。 With the need of the other set of line close to the wall surface, increase the wall is too wide, otherwise affect the installation of the door line.

(2) the width dimension calculation should be on the increase was on the wall after the benchmark measurements, ( Focus on custom home network, learn customization) for free every day Measuring method with the above steps are the same.

note: here will be subject to outside the door line, single for a fixed position, when considering the reserved space.

3. Shortcut: under the condition of without any increase in wall body, directly on the plane wall ( The corresponding wall projection) , according to the corresponding wall nail after two 35 mm width of real wood article also solve the problem.

2, push and pull box the size was confirmed with the above method.

hotel wooden door installation conditions

1. Wooden door must use the reserved hole installation method, it is forbidden to install while the practice of build by laying bricks or stones mouth.

2. Install the hole wall humidity & lt; 25%, if the humidity & gt; 25%, should be moistureproof isolation layer in installation on the wall.

3. Installation site clean and tidy environment, mixed and disorderly, crossover operation. Hotel wooden door must be in the installation hole surface engineering ( Such as: floor tile, stone) After the installation, at the same time, after the wall putty scraping and sand ( Metope to stick wall brick, stone hole, must be fully posted on the hole side) It is installed for operation.

hotel - wooden door manufacturer - Installation materials: iron fittings, 60 nails, 25, and 20 self tapping screw, 502 glue, small towels or cotton, wood chips, wood, hair brush, foam glue, white glue, locks, hinges, door suction, moist insulation materials of wall.

hotel - wooden door manufacturer - Installation tools: electric hammer, hammer wood, plane, flat file, sawing fine-tooth ( Hacksaw) Hammer, screwdriver, square, tape measure, messenger wire, spirit level, electric drill, openings for drill, punch, the corresponding specifications.